You are here: Home » Forum
Results 1 to 4 of 4

Thread: Europower pmp1000 mixer cut out problem

  1. #1

    Europower pmp1000 mixer cut out problem

    My pmp 1000 mixer keeps cutting out when singing and talking on mic can anyone reccomend the best way to balance all faders and gain controls to stop this happening these types of mixers are new to me always had basic amps before, thanks

  2. #2
    Hi Andy,

    Sorry to hear that you are having trouble with your PMP1000. This may be something that is not quite right with your mixer.
    Just to be sure, please tell us:

    1. How many speakers are connected and to where.
    2. The impedance, in OHMS of each speaker.
    3. the position of the AMP MODE switch, found in the upper right part of your PMP1000.

    Thank you for your information!

    Best Regards,
    Glenn Slater
    Specialist, Product Support Web
    MUSIC Group US

  3. #3
    2 speakers connected to rear via speakon leads
    8ohm speakers i think but will check when at club later, what is the difference if 4 ohm
    amp mode switch set to main

  4. #4
    Hi Andy,

    Please excuse the late reply.

    It is ok to use the 4 ohm speakers as long as the PMP1000 is not in BRIDGED mode. Then the minimum impedance should not be below 8 ohms, or damage will result.

    The gain on your PMP1000 needs to be nearly all of the way up for most mics. All of the gain is at the end of the turn of the knob. Now you shouldn't have to turn the final gain stage up as much.

    If you are already operating it this way, and you are getting the same results, For Technical and/or Warranty Support...
    For technical and warranty support for your BEHRINGER product, the best way to contact us is through our CARE department.

    You can contact us by phone at (1) 702-800-8290 for the US and Canada and (44) 1562 732290 in Europe.

    You can also contact our CARE department via email at We try to respond to every email within 24-48 hours, but please be patient if it takes longer due to the volume of emails we receive.

    Best Regards,
    Glenn Slater
    Specialist, Product Support Web
    MUSIC Group US

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts