You are here: Home » Forum
Results 1 to 2 of 2

Thread: Ucg102 support direct 0 latency monitoring

  1. #1

    Question Ucg102 support direct 0 latency monitoring

    I am unable to find where to switch on DIRECT ie not via the ASIO driver monitoring, I am using Cubase 5 on an extemily high end 64 bit pc, but the audio clicks and pops. I have tried all the settings I could, including different asio drivers. ie Behringer 64 bit, and asio4all.
    At home i run a Focusrite LE with no problem on a less capable PC without the audio pops. The UCG102 interface is unusable as it is.
    Thanks in advance for any help.

  2. #2
    Hi Clifford,

    There is not a direct monitoring feature on your UCG102.

    The clicks and pops usually come from buffer settings on your software. Check to see how to set them on Cubase 5.

    Other wise, a UCA202 will allow for direct monitoring.

    Best Regards,
    Glenn Slater
    Specialist, Product Support Web
    MUSIC Group US
    BEHRINGER

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •