Ucg102 support direct 0 latency monitoring

[Clifford Stanton]

I am unable to find where to switch on DIRECT ie not via the ASIO driver monitoring, I am using Cubase 5 on an extemily high end 64 bit pc, but the audio clicks and pops. I have tried all the settings I could, including different asio drivers. ie Behringer 64 bit, and asio4all.
At home i run a Focusrite LE with no problem on a less capable PC without the audio pops. The UCG102 interface is unusable as it is.
Thanks in advance for any help.

[Glenn Slater]

Hi Clifford,

There is not a direct monitoring feature on your UCG102.

The clicks and pops usually come from buffer settings on your software. Check to see how to set them on Cubase 5.

Other wise, a UCA202 will allow for direct monitoring.

Best Regards,