You are here: Home » Forum
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Behringer X-Dante Card and Bose PM8500 Dante Network Card

  1. #11

  2. #12
    Thanks for the links...should x32 be master or slave? I'm still not seeing where I send signals from the x32 to Bose on the routing tab in Dante. I'm assuming the tx is x32 and the rx is Bose?

  3. #13
    Tx is x32. Rx is bose.

    Do not change master/slave. This is only for specific setups and should not be altered.

    In the dante matrix software x32-channels 1-16 should be the same as mixbus1-16 if you setup the card tab to be out1-8, out9-16.
    x32, x32-rack, s16, p16, iNuke 6000dsp, deq2496, dxc2496, src2496, misc other behringer gear, StudioLive 24, StudioOne Pro, Cubase 4, Ableton Live 8 Suite, Reaper 4

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •