You are here: Home » Forum
Results 1 to 3 of 3

Thread: firmware updates

  1. #1

    firmware updates

    Just got a x32 and love it so far.

    Will i need to update each firmware update in order or just the latest one?

  2. #2
    Quote Originally Posted by Aaron Stone View Post
    Just got a x32 and love it so far.

    Will i need to update each firmware update in order or just the latest one?
    Just download the latest version 1.09 onto a flash drive, insert into the x32 and power up. Should update automatically from there

  3. #3
    Quote Originally Posted by Aaron Stone View Post
    Just got a x32 and love it so far.

    Will i need to update each firmware update in order or just the latest one?
    Dear Aaron,

    You only need to load the most recent version of the firmware.

    The X32 firmware can easily be updated by performing the following steps:
    Download the new console firmware from the X32 product page onto the root level of a USB thumb drive (FAT formatted).

    Plug the USB thumb drive into the top panel USB connector while the console is turned off

    Switch the console on. While booting, the X32 will run a fully automatic firmware update,
    which will take 2-3 minutes longer than the regular boot sequence

    A few very slow sticks might not get recognized during boot. If the update process does not take place, reboot the console while the thumb drive is attached and the console is powered up. This can be done by either changing the sample rate (on the setup page) or pressing the reset button (behind the small hole between the AES/EBU and MIDI OUT connectors on the rear of the console) with a needle or similar. Alternatively try another USB thumb drive.


    Chris Painter
    Specialist, Product Support
    MUSIC Group
    BEHRINGER

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •