I have a question for you in regards to your post. So that I understand correctly, are you saying that if there is a frequency point of 220Hz and you want to take it out using the Graphic equalizer you would like to have a 220Hz frequency slider instead of having to use both the 200Hz and 250Hz sliders on the GEQ or TruEQ. Am I understanding this correctly?
Specialist, Product Support HOW
In my analog days we had a unit called the Orban Paragraphic EQ. Above each slider there was a knob which let you adjust the frequency.
Maybe we need one of these as a plugin?
Hi.It would be nice if we could copy paste GEQ -A to GEQ-B.It would also be nice to be able to name the GEQ also.
Concerning the F/X returns,it would be nice to have an EQ.
Hi, just got my new X32. It came with Firmware 1.07.
FTR, in updating to 1.13, a 16GB Sandisk Cruzer failed, but a 16GB PNY flash driver worked. Both were FAt formatted prior.
The x32 is almost a specialized computer for sound processing and can be seen has another motherboard. If a USB stick does not work just try another one exactly as you did. I got the exact same problem and was not surprised since I often have the same kind of problems when working on computers.
I'd like the fx inserted on the main bus to be 2.1 aware so that i.e. the precision limiter can be used with the LCR or LR + mono for applications that uses aux feed subs or similar common configurations.
Please, also note that currently it's not possible to setup the insert to be 'main mc' and 'main lr' on the two separate insert points for a single fx.
Lockable udk's. This to avoid reconfiguration of udk's when changing scenes.
Lockable mute groups . Rhis to avoid reconfiguration when changing scenes.
Additional scribble colors
User designable scribble icons
Monitor level on the un-assigned fader in matrix mode
One extra matrix for the un-assigned fader in matrix mode.
Make usb 7/8 reconfigurable.
Smaller blocks than eight. Seems to be possible for the auxes.
Fx-sends outside of the normal 16 busses.
User configurable fader layers.
Extend mackie to the whole surface.
Remove clip indicator when daw outputs 0dBFS. It should only clip if additional digital gain has been applied.
Change the usb power handshake so that ipad knows that the x32 is self powered and not powered from usb.
Move the expander to the gate section instead
Do not flip the faders on the right side configured as bus to dca when bus master is selected.
Display the new x-over filters as lshv/lcut and hshv/hcut on the actual console leds for clarity.
Mono bus should be sends-on-fader enabled.
Udk's with user ediable text.
Named fx should be shown when assigned to faders.
The fx-rack implementation needs to be reviewed since all new fx puts a limitation to it.
Since the archwave dm1500 can handle up to 36 channels on usb it would be nice to add some extra routing for those four channels.
Consistency in the osc-parameters when transfering data back and forth the x32.
Add gui to select the already implemented slope of the shelving filters
Digital gain for the headphone output.
I would like to see a modulating tape delay or analog delay in the effects section. Thanks!
I have a 2 hour recording done off the mains to a USB stick from Sunday morning (04/21/13). I haven't listened to the entire recording front to back, but I did happen to notice a couple of incidents where there were glitches where bits of the recording was missing. It's unclear how long those periods might have been, but it could have been anywhere from under a second to a handful of seconds.
Has this been reported before?
If I were to provide you with the raw recording (or an excerpt with just the incidents in question), how would be the best way to do that?