Search:

Hi Serge,

Sorry to hear you're having issues with both of these. I've heard this before on a different board with the same DSP PCB. I'm fairly certain that if the DSP PCB is replaced it will solve...

Hi Trevor,

I'm not sure where you saw that other spec but I would trust the one stated in the spec sheet. Cross referencing the spec sheet myself I can say yes all of that is correct.

Kind...

Hi Lars,

S1-S3 as this will give you a +4dBu operating level while L2 is set at -10dBu. Use the mic preamp on the MOTU if you don't want to change the configuration.

Also, I'm sure you have...

I haven't heard this particular issue happening so I believe that it's a pretty rare one. In this case the only remedy here would be to get the unit serviced by our CARE department if it's still...

"Program power" or "music power" is generally given as a spec where music is suppose to be playing at. It's the general idea of where the volume should be and typically half the peak but it's sort of...

Hi Eifion,

All the available specs for these products are found in the user manuals.

http://www.behringer.com/assets/EP2500_P0183_M_EN.pdf...

Hi Mark,

If you're playing at very low levels then the signal level shouldn't be a factor. I wonder if it's the power voltage issue from wherever you are using it since it works fine at the...

Hi Mark,

Can you go through your setup for us? What kind of speakers you have connected, the ohm rating of those speakers, how many you have connected per side and what amp mode are you running it...

Hi Brett,

All that looks good although I think you're going to need some microphone preamps at some point and that RX1602 is only line inputs. Depending on how many channels you anticipate there...

Hi Samuel,

Your setup looks correct to me. You could test the audio feed using a regular mic cable going to a mixer but it should only be a signal flow test and not a quality of sound test. Start...

Hi Se,

This is quite a long cable run here which might be the culprit. First I would try to get the pre-amp closer to the mics if possible as it's better to have amplified signal closer to the...

Hi Henry,

Yes of course, that counts!

Kind Regards,

Hi Dan,

I have sent you a PM regarding this. Please respond and I'll see what I can do to help out.

Kind Regards,

Ben

Hi Ian,

Sorry for the delayed response! The PMP3000 doesn't require speakers to be connected when in operation so what you are hoping to do will be fine. Make sure to use the line level outputs on...

188

You'll need to choose the Q802USB as the device you wish to use in Acid. Consult the help guide to find the audio setup menu. Then you should be able to choose channel one for one track and...

Hi Fernando,

The issue here is that X1204USB only has the capability to output two channels via the USB. Now it is possible to use the mixer as mentioned with the Alt 3-4 outputs but using an...

Hi Bert,

I know you have already gone withe the X1222USB but it would be worth it to mention that the X2442USB has an FX OUT which you can return to a channel easily as well. You would also have...

Hi Jiri,

This is a really good solution for this product! Thank you for sharing.

You shouldn't have to turn up the faders all the way here. I suggest looking at the GAIN knobs and turn them up slightly more than 3/4. Set your faders to the unity gain mark which is the "0" dB...