You are here: Home » Forum

Search:

Type: Posts; User: Robert Lofgren

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Thread: X Air?

    by Robert Lofgren
    Replies
    101
    Views
    20,872

    Sorry, but that is probably more than I can...

    Sorry, but that is probably more than I can handle. It's a cool project but...

    The issue at hand isn't the protocol but rather the syncing clocks. This must be implemented in a fpga/clpd for this...
  2. Replies
    10
    Views
    226

    There are a couple of screws under the rubber...

    There are a couple of screws under the rubber matt...
  3. You'll need to forget your studio skills for a...

    You'll need to forget your studio skills for a second.

    In live playing you have much more dynamics for your speakers to take care of compared to the controlled sound of a properly mastered...
  4. If it is an actual eprom then you'll need special...

    If it is an actual eprom then you'll need special equipment to erase and reprogram it and this will cost you more than replacing the chip...
  5. You don't say where the sync is lost, but I'm...

    You don't say where the sync is lost, but I'm assuming it is in the daw.

    This may, or may not, be the issue but since the rack is connected to the dante network it should have its clock derived...
  6. 96k will make it sound much worse than 48k. By...

    96k will make it sound much worse than 48k.

    By enabling 96k the fat-channels on all outputs will be gone and two fx (one reverb and one delay) will also be gone. I don't know about the geq.
  7. If the laptop sits on (or very close) to a big...

    If the laptop sits on (or very close) to a big metal plate, like a metal table, the wifi will suffer. Also, if the laptop has bluetooth enabled and/or some other wifi device like a phone close to it...
  8. Replies
    4
    Views
    95

    According to the manual Have you turned off...

    According to the manual

    Have you turned off this feature by misstake?
  9. 1) Yes, this is normal. 2) This is not normal....

    1) Yes, this is normal.

    2) This is not normal. Verify with a cable connection to see if the wifi is the issue.
  10. £1700 was mentioned... Their ipad app look...

    £1700 was mentioned...

    Their ipad app look reaally good. It is only 3ru for 32 channels. Presonus version is 4ru.
  11. Replies
    17
    Views
    440

    If the drummer puts too many mics from his kit...

    If the drummer puts too many mics from his kit into his ears they will probably sound muddy and less defined due to all the ringing heads and no gates/expanders and no proper eq on the p16m. The toms...
  12. Nope, just grab the latest and greatest...

    Nope, just grab the latest and greatest firmware...
  13. Keep a live thread here instead. It will help...

    Keep a live thread here instead. It will help others in the future. As you said it applies both to the m32 and x32.

    We still don't know if this forum will handle the m32 as well or if midas will...
  14. Replies
    5
    Views
    130

    Have you tried gloves that is made for tablet use?

    Have you tried gloves that is made for tablet use?
  15. Replies
    17
    Views
    440

    Most drummers would only want kick and overheads....

    Most drummers would only want kick and overheads. Sometimes they'd like to have the hihat. Never had one wanting the toms.
  16. Capture is based upon s1 and it will also pop out...

    Capture is based upon s1 and it will also pop out of record w/o any warning and really hate that...

    The reason for s1/capture to fall out is that your computer is detecting dropouts and will...
  17. I'm having trouble understanding your FR. Can you...

    I'm having trouble understanding your FR. Can you describe it a little bit more?
  18. Replies
    5
    Views
    288

    I've never encountered a situation where the...

    I've never encountered a situation where the aux-feed sub didn't sound better than a traditional LR setup.


    If you use aux-feed sub then you'll probably want to treat the tops as fullrange within...
  19. I would probably set it up as drums, bass,...

    I would probably set it up as drums, bass, guitars, ambience mic for iem's, vox from left to right. One fader per used mic/instrument. I usually put the vox on the last faders for my own convinience....
  20. Press sends-on-fader and select the proper bus...

    Press sends-on-fader and select the proper bus layer on the right and press select for the mixbus that goes to your monitor.

    Press the fx-retn on your left to select that layer and then raise the...
  21. The main LR control can't control the monitor...

    The main LR control can't control the monitor level. If that control is pulled down and he hits solo the monitors will blast!
  22. Any of the outputs can be assigned as monitor...

    Any of the outputs can be assigned as monitor outputs and therefor have all the solo-bus functionality and like.

    The only difference is that the dedicated monitor output has an analog level...
  23. The x32 has a dedicated monitor output with an...

    The x32 has a dedicated monitor output with an analog level control.

    On the rack this control is shared with the headphone output, but on the consoles the levels are separate.
  24. Replies
    6
    Views
    234

    This is something that many people find confusing...

    This is something that many people find confusing - There is no limitation on the aux inputs!

    The limitation lies within the aux layer channelstrip. By default the aux inputs are assigned to the...
  25. Replies
    6
    Views
    236

    Just take your iphone and ipad, connect them...

    Just take your iphone and ipad, connect them using facetime, skype or similar stuff. Connect one device to the mixer using the handsfree connector.

    If you have a computer at your mixer you can use...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4