You are here: Home » Forum

Search:

Type: Posts; User: Tim Padrick

Page 1 of 9 1 2 3 4

Search: Search took 0.01 seconds.

  1. Is this on any channel, or one channel in...

    Is this on any channel, or one channel in particular? If the latter, with any source, or one source in particular? If the latter, what's the output connector and configuration (unbalanced,...
  2. Thanks Paul. Here's a direct link to the chart:...

    Thanks Paul. Here's a direct link to the chart: http://x32wiki.music-group.com/images/2/21/S16_modeselection.png
  3. Replies
    22
    Views
    1,282

    As was touched upon, when using "New York...

    As was touched upon, when using "New York compression", one must insure that both paths have the same latency. If they don't, there will be comb filtering that will make things sound quite bad. ...
  4. Replies
    4
    Views
    276

    I've never heard an enhancer that I liked on the...

    I've never heard an enhancer that I liked on the entire mix. One might be OK for an individual channel - though I have never tried one that way.
  5. Replies
    7
    Views
    272

    Before using any USB flash drive, format it. ...

    Before using any USB flash drive, format it. Some have goofy crap on them that does not play nice with some devices.
  6. Replies
    3
    Views
    232

    You can insert an FX on only one channel at a...

    You can insert an FX on only one channel at a time. Route the channel's insert send to the FX in, and the FX out to the channel's insert return. Then turn on the channel's insert when you want the...
  7. I've seen folks say Mode 1. I've seen them sat...

    I've seen folks say Mode 1. I've seen them sat Mode 1-6. I don't recall the term Mode being used in this fashion in the manual. ?
  8. Nothing's perfect. Even Lexus has a service...

    Nothing's perfect. Even Lexus has a service department.
  9. Replies
    14
    Views
    551

    The AV side needs an internet connection. Using...

    The AV side needs an internet connection. Using two routers allows the AV side's to have private wireless. It all works perfectly.
  10. Replies
    17
    Views
    856

    As soon as someone who wants an internet...

    As soon as someone who wants an internet connection sees your SSID, they will try to connect, busying your router.

    I've yet to see anyone enumerate the supposed problems caused by turning off SSID.
  11. Replies
    37
    Views
    2,044

    Install a right angle plug, and you'll be able to...

    Install a right angle plug, and you'll be able to leave them plugged in (if it fits in the handle hole).
  12. Also a symptom one can see when two units are not...

    Also a symptom one can see when two units are not clock sync'd. They manage to work for a while, then their clocks drift far enough apart that the card thinks the computer is gone.
  13. Replies
    14
    Views
    551

    Here's an example. You can ignore the items that...

    Here's an example. You can ignore the items that don't apply to your situation. (I tried to upload it, but it would not work.)

    http://www.padrick.net/LiveSound/TheaterNetwork.jpg
  14. Replies
    14
    Views
    608

    In such a case, I split the tracks to two...

    In such a case, I split the tracks to two channels, one for the house mix, and one post-fade for the monitors. This makes it very fast to adjust the monitor feed when there are changes in track...
  15. I expect that using the X32 will sound better...

    I expect that using the X32 will sound better than the DRPA, which is a marginal sounding unit.
  16. Sounds like the tip side of the balanced audio...

    Sounds like the tip side of the balanced audio output IC has gone bad.
  17. Replies
    19
    Views
    785

    Why use USB when Ethernet is available?

    Why use USB when Ethernet is available?
  18. Replies
    7
    Views
    257

    FX in the wedges usually cause more harm than...

    FX in the wedges usually cause more harm than good.
  19. Replies
    10
    Views
    397

    "2. Connected X32R via LAN cable to router as...

    "2. Connected X32R via LAN cable to router as 192.168.0.127 Subnet 255.255.0.0
    3. Connected Ipad4 IOS 7.0.6 to WiFi
    4. Got IP 192.168.10.100 from router"

    All units' IP addresses should match in...
  20. Replies
    48
    Views
    5,044

    IIRC, V2 on the Compact allows the channels to...

    IIRC, V2 on the Compact allows the channels to take over the DCA fader bank (Midas Fader Extend). There should be no reason this cannot be implemented on the biggun - the trick is figuring out how...
  21. Replies
    3
    Views
    270

    One advantage to the rack would be the...

    One advantage to the rack would be the insert-able effects - if it's a little dry under the balcony, insert a reverb on the under-balcony send(s) and off you go.
  22. Replies
    2
    Views
    284

    "How about an AVIOM card for those of us who have...

    "How about an AVIOM card for those of us who have already invested in an extensive AVIOM system (this was what ultimately caused a colleague of mine to buy an LS9 instead of an X-32)."

    With what...
  23. Replies
    24
    Views
    1,539

    Put things together on a layer that tend to get...

    Put things together on a layer that tend to get in something else's way. Guitars and keys get in the way of the vocals (and each other), so put them on 17-32. Kick and bass get in each other's way,...
  24. Perhaps he can connect the computers via Ethernet...

    Perhaps he can connect the computers via Ethernet and use Dante Virtual Sound Card on the computers to get them and the programs to talk to each other?
  25. I too find that many line outs will drive buds or...

    I too find that many line outs will drive buds or phones just fine. Give it a try.
Results 1 to 25 of 206
Page 1 of 9 1 2 3 4