1. Buses are configured in pairs, even they are unlinked
2. You only can select a source that is routed in the routing tab.
But you can use
The presets are just a set of parameters, that are copied to the selected channel/FX/bus/...
After that there isn't any relation between the preset
Meter Bar setting is where?
I fear that this is a hardware limitation. The AUX / P16 out / Out 1-16 routing is a single signal routing, and is done "inside" the mixing
We moved our amps off stage.. and bass goes direct into FOH.. so only sound on stage technically is drums.. We have used Drum shields on and off. I
© Copyright 2011. MUSIC Group IP Ltd. All rights reserved.