If you are soloing the channel it is in mono. Any point after that it would be in stereo.
Yes, that is what I ended up using but even those go through the preamp and processing. You could accomplish this on a analog board by using the TRS
That's a NO. Worked on the main headset out, but not on the bus.
When linking two channels, go under HOME and mains tab, would it help setting the Mono on and rising the mono fader AND lowering L/R faders? I'm not at
By the way, those mutes on that Sends page are not channel mutes, I discovered. In other words if you mute one of those, they don't apply the mute to
Section Widget
Categories Widget (Show All)
Recent Articles
Recent Article Comments Widget
Recent Blog Posts
Stereo Pan Problem
If you are soloing the channel it is in mono. Any point after that it would be in stereo.
Bill McKelvey 7 Hours Ago